My work got one of these on my suggestion over the summer and its been printing amazingly until last month when it started having bed adhesion problems. I'm used to dealing with PEI or glass build platforms and use PVA to get everything to stick better but don't have the most experience with the build tak surface. I've played around with just washing it with a little soap from what the manual said but I was wondering if PVA glue will cause any problems. Does anyone agree, disagree, or can suggest something else?
Wonder why Sindoh doesn't sell a software upgrade to DP200 owners so they can use open source filaments and not have to buy closed source filaments? This question was asked Sindoh by Fabbaloo and you can read their reply here:
The DP200 and 3DWOX 1 use the same nozzle assembly, filament feeder, and filament holders so why do they say the DP200 filament feed is different than the 3DWOX 1?
Wonder why they will not offer a upgrade for the DP200?
Hi all - I have a DP200. I'm liking it MOSTLY. I'm having a really hard time getting the ABS to print correctly using 3Dwox and I am having NO LUCK whatesoever getting Simplify3D to work. I cannot get a good first layer no matter how hard I try. When it works - it is GREAT. But I am having a hard time getting very delicate reliable prints like I used to get with my Monoprice Maker Ultimate.
Hello, just got my new printer and tried to print ABS and PLA. Works fine. But iam disappointed of the noise level the printer produces. The case fan of my device is very noisy, especially when printing from a PLA cassette. It runs full sped and the whole casing vibrates. I checked noise and got 53db in one m distance. Far away from the 40db Sindoh is promising. Maybe the fan in my device is faulty? Any 3DWOX1 users here have the same issue?
With ABS its really quite, cause fan is not on full speed.