Hey everyone, I recently salvaged a printrboard Rev D from another printer...
And I'm running into issues with the Z motor not holding after a move command is given.
I have no firmware access, as I am unable to successfully compile on Arduino from numerous verify errors. So all changes need to be done by Gcode and saved using the M500 command.
Basically, X and Y after a move, holds its position, but the Z motor free rotates. This is immediately after a movement command.
Does anyone know whats wrong? Ive also swapped stepper motors and the result is the same for the Z axis.
Have you found any good enhancements for a Printrbot Simple Metal?
This one is amazing and works great: http://www.thingiverse.com/thing:507944
This one I haven't tried to attach yet, but it's made for the old wooden model, so not sure if it will fit mine: http://www.thingiverse.com/thing:258459