P3Steel

Hi all,

I recently purchased a P3 Steel v4 Frame and apart from the 10mm smooth rods on the Y Axis I assume v2 printed parts are compatible? I was looking at printing up all of the toolson edition parts that I would need to complete the printer.

Did a Few Minor upgrades to the NCS P3Steel Base Printer, the Cordobesa Printer gave me a couple of Ideas so I redrew some stuff in the design.
mainly the Y motor mount now has a brace and no longer needs dual plates (can still accept dual plate style if desired)
and the extruder cut parts for all metal direct mount to Nema 17 motor similar to Cordobesa pictures
check it out and read the discription
http://www.thingiverse.com/thing:1125537

and thanks to this for some ideas http://www.thingiverse.com/thing:1528308

my Free downloadable DXF version will not get these upgrades
http://www.thingiverse.com/thing:687929

has any body go a source for steel parts to upgrade this i know the gape between the motor and smooth rod has to be around 22mm im using prusa metal carrage any ideas

Upgrading to a multi extruder with diamond head i needed another stepper .. so i designed one .. i named it onestep as i only needed another one stepper !

found here http://www.thingiverse.com/thing:1804666

Boards available in my tindie store ..

Printed an external case which hosts the ramps board and the lcd display . i designed a breakout board .. found here http://www.thingiverse.com/thing:1791956

boards are available in my tindie store !