looking for a kossel project
that uses the wheel system on the sliders and has some details like the bolts to use
With the arm measurements and which bearings to use, in the past there were a lot of delta designs in this style but they just disappeared ... can anyone point me to one?
I am using here profile 2020 with measures of 240mm and 680mm height
Does anyone have or know where to find the start and stop G codes for the knockoff Kossel (Delta) Printer 180 x 180 x 300. The ones in Cura 4.1 don't work.
I'm trying to print a new design for a protectionplate for the underside of my Kossel, The plate has a diameter of 210 mm, with some mounting gear that exceeds that diameter (max 213 mm). I thought the build volume was 230 mm as advertised, but I can't go beyond the 210. When it first exceeds the 210 mm one of the arms gives a "kloink" and the bed-leveling after that is totally off, until a cm above the correct position, re-leveling solves that btw.
In the settings (move axis) the max. for the X and Y goes from -105 to 105 mm (=210 mm). Manually you can move it to ca. 115/230 mm. So is it the firmware? or is it a problem with the hardware ( the "kloink")?
Rods are 265 mm (axis to axis)
Buildplate 240 mm.
UPDATE: according to two fellowmakers (thanks), Marlin 1.1.8 and 1.1.9 should give no problems.
Last night while upgrading my effector on my Anycubic Kossel Linear Plus I zapped (static) my GLCD (on the metal bezel of all places), and probably also blew some I/O's my Re-ARM which is attached to it. I'm waiting on a replacement display to check it out before I know for sure. I've been using the Re-ARM with RAMPS 1.6 (running Marlin 2.0) for a while and like it for the most part, but the Re-ARM is far from perfect (but it is cheap). If my Re-ARM is blown, I would like to look at other options. The only thing that I think I would really call a need with a 32bit board is Marlin support, and stepstick driver support, any suggestions or experince with em?