I'm trying to print a new design for a protectionplate for the underside of my Kossel, The plate has a diameter of 210 mm, with some mounting gear that exceeds that diameter (max 213 mm). I thought the build volume was 230 mm as advertised, but I can't go beyond the 210. When it first exceeds the 210 mm one of the arms gives a "kloink" and the bed-leveling after that is totally off, until a cm above the correct position, re-leveling solves that btw.
In the settings (move axis) the max. for the X and Y goes from -105 to 105 mm (=210 mm). Manually you can move it to ca. 115/230 mm. So is it the firmware? or is it a problem with the hardware ( the "kloink")?
Rods are 265 mm (axis to axis)
Buildplate 240 mm.
UPDATE: according to two fellowmakers (thanks), Marlin 1.1.8 and 1.1.9 should give no problems.
Last night while upgrading my effector on my Anycubic Kossel Linear Plus I zapped (static) my GLCD (on the metal bezel of all places), and probably also blew some I/O's my Re-ARM which is attached to it. I'm waiting on a replacement display to check it out before I know for sure. I've been using the Re-ARM with RAMPS 1.6 (running Marlin 2.0) for a while and like it for the most part, but the Re-ARM is far from perfect (but it is cheap). If my Re-ARM is blown, I would like to look at other options. The only thing that I think I would really call a need with a 32bit board is Marlin support, and stepstick driver support, any suggestions or experince with em?
i have a kossel XL 3d printer and i whant to upgrade it to a z-probe. only the problem is
When i googgle it i get a lot of links.
but when i try some things nothing works..
So i hope that some hear can help my.
My setup of the 3d printer is
Ramps 1.4 with dvr8825.
marlin firmware 1.0
So im just havin an issue with my Kossel Linear Plus where my hotend wont heat-up, not even a degree.
What i've tried and seen:
- When putting something to print it shows : 18/200 . So it can read the temperature, so i think that means thermistor rod that goes across the block its fine, right?
- I've connected it to pronterface, i can home, send commands but when i set the extruder to high temperature, same, doesn't goes up and the graph on pronterface shows nothing.
- Have checked every motherboard connection, no changes.
- I have tried to set the temperature without the layer fan, still same. Not a single degree.
- Can't adjust PID either.
What could it be? Fried motherboard?
Thanks in advance.