Yesterday I have started with the installation of Klipper on a AnyCubic i3+ Prusa (my first time)
original TriGorilla board,
with original TMC A4988 stepper driver, without chnages in vref
original setup for the axis
original extruder and MK8
Raspberry Pi 3B
Octoprint, latest version
Klipper latest version
new bearings ;-)
I had to configure the printer.cfg by my self, i didn't find in the web - hard work to find all necessary information like the pinout for the board and so on. Actually all axis, switches, display, heater for bed and noozle are running well. I have testet alle safety functions and checked PID Tune.
First test with 100mm/s was cool. 2nd test with 200mm/s was Impressive - with a nice surface!. It feels like having a new printer ;-) !!
Today I want to optimize the "Pressure Advanced" function, actually i have choosen some save values, and I will try to find out the max. usefull speed for the printer (becuase of the moving printer-bed).
Is there anyone who as tried Klipper on an old, printer like that? Someone who want to share his expirences?
Hi folks. I've written a little post processor to deal with the bug in Simplify3D which generates the bad gcode which triggers the dreaded "Move exceeds..." error. Anyone who's interested can have a look at
I keep seeing this message in the klipper message window. It does not seem to cause any problems, but I am curious about them. I also see this in the serial.log:
2020-03-30 11:51:50,693 - Recv: // Unknown command:"OBJECT"
I see lines like these in the gcode created by Cura:
It appears this is the origin of these messages. Is there a way to make klipper stop complaining about these?