Loading

MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.

Download Now

Unknown command:"OBJECT"

by markwinger

I keep seeing this message in the klipper message window. It does not seem to cause any problems, but I am curious about them. I also see this in the serial.log:
2020-03-30 11:51:50,693 - Recv: // Unknown command:"OBJECT"
I see lines like these in the gcode created by Cura:
@Object NONMESH
@Object myfile.stl
It appears this is the origin of these messages. Is there a way to make klipper stop complaining about these?

unknown error
View Comment

Klipper on Ender 3

by dmb56

So far liking Klipper on the Ender 3 and Pi. The Ender was killing my SD cards frequently. Just using Octoprint solved that but was slow. Klipper got things faster and with virtual SD card even faster. Are some Gotcha's - No M600 filament change for one so multicolour signs out of repertoire for now.

View Comment

[Solved] Z-probe

by Varazir

Hello,

Can you connect a z-probe to the raspberry pie and use Klipper to level your bed ?

Posted on Github as well

View Comment

Klipper updates

by Knaudler

Listing of Klipper Versions
(update with git pull and sometimes you have to flash new Klipper Firmware on your Arduino)

View Comment

Anet A8 and Klipper Firmware

by Knaudler

my Anet A8 works with original Board (v1)
with newest Marlin without Problems

flashing the Board with Klipper hex, works on original Anet Board
but only with 57600 Baud
so I had to flash a new Bootloader on the original Anet Board
using Optiboot - flashing with an AVR flasher
after this, the Board works with 250000 Baud

I think there is no need to flash better bootloader, but it works faster and optiboot is smaller

next Days I will write an Installation guide...

View Comment