I'll try to turn my old, anything but not reliable K8200 into something like prusa or CR10 with 300x300mm heatbed (I didn't figure out Z height yet, but seems like it can be way over 200mm). Already I have just frame and motors left, everything else is rebuilded :D... (Ramps 1.4 full graphic smart controler, 1,75mm direct drive extruder, J-head v6, GT2 belts, optical X and Y endstops, of course custom marlin fw and a lot more...)
Ithink I can use MK2S/MK2.5 X axis and extruder assembly, with one Z motor and belt connected leadscrews.
Is anyone interested in this project?
Hy all..i need your experience..=)
So i have a K8200 and do alot of moddings on it..
What ive done.
-E3D V6 Hotend
-Tensioner dor x and y axis
-Upgrade the Headbett to 24V with a SSD Relais
Mount the Original Z axis Upgrade
Mount the original Borsolit glass
So atm im at work to upgrade it again...the controller K8201 and K8206 is allready orderet..
I orderet a E3D Titan and a BLtouch sensor to..
The new bed from K8206 isnt headet so i rebuild it by my own.
Now i have sone questions.
-is here someone how had installed the BLtouchsensor on his K8200 Printer and can tell me how to install the wires and what i must chance into the firmware?
Wen install The BLtoch can i remove the original Z endstop?
-Is here someone how had the K8206 too and can tell me what i must chance in the firmware for the bigger bed size?
-someone cab give me little tips to install the Titan?
I like to write how good the own rebuild of the new bed works..
And im sorry for my english..
Thx to all
I have this idea for looooong time... It is a printed case for a small switch. It has 2 main moving parts: protected start button and emergency stop button...
I need some ideas for this project like where to mount it on the printer and how to mount it on the printer.