I just picked up the Iron Patriot Armor models from http://do3d.com/product/3d-printable-iron-man-patriot-armor/
This will be my first printed armor, and I am hoping not to have too much trouble with it. I don't have the best 3D printer, so I am taking a gamble and will have to test some prints using http://www.gearbest.com/3d-printers-3d-printer-kits/pp_337314.html
If anyone has any advice, I would appreciate it. I also need to side the armor down from 6'5" to 5'9".
What software do you all recommend? I am told Meshmixer should do fine, but some people recommend Netfabb?
Hi I am totally new to 3 d printing . I am using a wanhao 5 plus large machine . My very first attempt actually went quite well I think ! I made a mavic drone controller holder . So project 2.. I want to make an ironman suit . I have just started the right hand .. so a long way to go ! But ... I have a few issues already with a few bits of slightly running on the wrist section .. any tip or hints would be greatly appreciated .