Hoping for an idea on where to turn next with a problem I have.
I had accidently bent a couple of the stepper driver pins reinserting it in the board during some troubleshooting.
I had tried to run a print without knowing about the pins, and the filament stepper motor has not worked since.
I have - replaced the stepper driver, replaced the stepper motor and the stepper motor cable.
None of these things have solved the problem.
I have no idea what to try / check next!
These are all valid during april
3D Printer Deals
Discount Code: f7f6d0
Discount Code: 39d55c
Discount Code: cf11d5
Discount Code: 38d25b
3D Printer Parts (Discount Code: 23e6f5)
303010mm DC 24V Cooling Fan - https://bit.ly/2FTTQwc
2GT 6mm 0.76m Rubber Timing Belt - https://bit.ly/2VtMiqQ
MK8 Extruder Gear- https://bit.ly/2I8SJMZ
12V-24V MKS-GEN L Main Board With 4988 Driver Board - https://bit.ly/2G90n7C
2A 125V YD-012-13.5-2 Limit Micro Switch - https://bit.ly/2VwxRSF
20T GT2 Aluminum Timing Pulley With Tooth - https://bit.ly/2VwOH47
Stepper Motor - https://bit.ly/2TlGEJp
24V 30W 620mm 1m Single Head Cartridge Heater Heating Rod - https://bit.ly/2U7HuFU
303010mm Part Cooling Fan - https://bit.ly/2Ilz23D
201611.5mm M6 Aluminum Heating Block (E3D v6) - https://bit.ly/2FYx6vk
1.75mm Filament 0.4mm Copper Nozzle (E3D v6)- https://bit.ly/2D7cjVy
310310*13.6mm Aluminum Heated Bed Plate - https://bit.ly/2I5hucZ
Hi everyone I hope someone can help me here.
On my geeetech i3pro b the printer bed stepper motor will no longer move freely, and takes a lot of force to move at all.
I thought the stepper motor was bad and replaced it, however I still have the same problem.
Hope someone can guide me in the right direction.