This group is about design and print failures, and how to iterate designs and settings to make them work. Laugh at what went wrong and share advice on how to get it right.
P.S. This isn't a group about complaining, it's a group about design iteration.
P.P.S. To add an image to your comment, type this with a path to your image:
(thanks to http://www.disturbancesinthewash.net/journal/2012/8/11/how-to-add-an-image-with-link-in-markdown.html)
Hello this formatted.
I've had my Tronxy for over a year now. I've learned a lot thru trial and error and have gotten some really good prints. I use Repetier slicer. A couple of days ago I started having problems with prints falling apart. I have tried changing filament, changing setting, changing temperature, changing models. I triple checked the bed level. When none of that worked I changed the nozzle thinking for sure that it was clogged. Still no luck. I can print flat on the bed OK, (see the green broom holder pic) but anything with any kind of wall or feature that builds up off the bed doesn't stick together. My last test was to try a desk top organizer that I printed successfully with the exact same settings and temp just a couple of weeks ago and it also failed. (see gray stringy pic). I don't know what is wrong. Anyone have any ideas? Thanks
I you have a clogging in a print, or you ran out of plastic befor the print is done: there is a trick!!!
But it very simple: If it was a small print: reprint it
But if 12 h print stops after 11h30, you may want to try this!
Don't turn off the printer you need the z position of the printer without having to home it.
Use any printer controller like pronterface or repetier, or the lcd knob of the printer to find out the z height where it stopped. Leave the nozzle to this height and keep it in note.
For exemple it is at z = 1,6
Open gcode with notepad (in windows, but there is probably a similar app for mac or linux)
Use ctrl-f and search for the height where it stopped. For this example, it stopped at 1,6mm
search for "G1 Z1.6" , then push enter.
This will highlight the place where the layer changes to this z height. It might imprecise: like 1.61 or 1.58 choose the closest G1 Z** point.
This will be the point where you want to restart the gcode.
I you want to remember this point, the tricks is to add some enters just before this line. It makes a space that will be easier to find later.
Then you want to keep an introduction that homes only x and y and set temperatures and all that needs to be set.
You'll search for "G28": it homes all axis. You'll change it for "G28 X Y" because you don't want it to home z, as it is already at the good height.
Then keep some of the following lines until you see the line G92 E0. This is the last line of the introduction that you'll keep.
So All what is after G92 E0 and the point of the # 4 should be erased.
I suggest a trick that is faster to select and erase what you want: cap + page down/up, then when you are close to the second point you can keep use cap but use the up down arrow.
When what you want to erase is blue, press delete.
Hope it helps someone.