I'm wondering if anyone has any thoughts or guidance on this issue. I've taken a look at the G-code and don't see anything out of the norm. Attached is the gcode for if anyone is curious. I'm printing a scaled up Leo benchy and am frustrated is stopped extruding. When I finally came to my printer I could manually turn the extruder while it was still printing. it stopped around layer height 4.8mmand was turning out amazingly otherwise. Yesterday I printed a bell siphon out of the same material with the same settings that limited out on the height.
Using Prusa Slic3r
I'm going to try it again a little bigger. if there's anything else info wise let me know.
Thanks ahead of time