I have worked with Keenovo for a few months to try and have Silicone AC Bed Heaters produced for our hot beds. They have shipped me the first test unit which will arrive tomorrow for me to try on my Creality Ender 5. I will video record the units (2nd is for the Tevo Tarantula, the other unit I attempted to aid in the production of) and capture all results. If the sample units are exactly shaped and spaced expect production to begin extremely soon for as much. The result will be far faster heat up times, more uniform heating and far higher temperatures for our heat beds (finally! No more waiting 22 minutes for a mere 110°C that isn't uniform across the bed). The Keenovo Silicone AC bed heaters produce uniform heat across their entire surface, reach extremely high temperatures (the unit on my CR-10S can reach 381°C and do so in only 4.5 minutes versus our Ender DC beds which are not uniform, won't go over 110°C and take 30 minutes to get there).
I will video record the heater and it's fitment, function and any and all possible problems the unit may have. If you'd like to see that video please reply with YES as your first line with all other responses and questions below that line.
This will also benefit us as the Solid State Relay doesn't draw anywhere near the current the DC bed does so that the current saved can be used by our motors and nozzle heater. Finally the Creality Ender 3, Ender 3 Pro and Ender 5 will be able to print in Polycarbonate, Nylon and other very high temperature filaments as the bed will be able to reach and hold temperatures required for as much, plus the additional available current will enable our nozzle heaters to reach the much higher required temperatures!
Great news for we Ender 3/3 Pro/5 owners.
Here is my guide for replacing your faulty XT60 connectors... if you have an Ender 3 this is probably a good idea.
Ender3 Built for ABS
This is a video of my Ender3 which is built for ABS w/Glass enclousure -
Here are all the features:
E3V6 Hot End
Multiple Power Supplies 12v/24v
Stepper Motor Dampners
NON Integrated Stepper Drivers
MKS Gen L V1.0 Controller Board
Bigger Controller Board Fan
Newest Marlin Firmware
Individual Control for Fan on Controller
2 - 5150 parts cooling fans
Pet's Fang Shroud
40 inch Wire Harness
Separate PCB for the PS on Heated Bed -24v
All new Nema 17 Stepper Motors -12v
Capricorn Bowden Tube
Temp Control Unit (Thermosat) for Heated Air
All Electronics Outside the Enclosure
Custom Stand for Spool Holder