MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
My cr10s seems to be over extruding the curve on this benchy it hasn’t done this before please help
Check your e-steps on extrusion bet its to high turn down 30 so if its 400 do 370 and try. Open pronterface heat to 180 mark 100mm of filament from extruder advance from pronterface on extruder 100mm see if it hits the mark on filament should stop at the extruder. If its to far away measure how much same goes for to close. Needs to be accurate. Adjust e-steps in the firmware or if your using Uart from menu and store settings.https://www.youtube.com/watch?v=3yIebnVjADM