I changed my board to a SKR V1.3 Marlin 2.0 bugfix.
Everything works fine, including TFT35, SD card ...
But if I heat up the hotend, it will exceed 5 to 10 degrees and the temperature will fluctuate.
The heatbed temp works well.
I used the stock PID values from the example config and also run a PID Autotune.
The Autotune gets me values far from the original ones.
Also with the new values stored it overshoots and does not hold the temperature.
Hello, just curious if anyone has any tips to look for to repair my box for my CR-10S. I was replacing the nozzle and there is a chance maybe there was a short, not sure, but the box will not boot up anymore. It is non responsive and I am not sure what to do or what to look for. I did pull the fuse but there was no issue with it. It was purchased from Mechestore so I am looking into that route. Anyone have any tips to what to look for? I appreciate any feedback. Thanks.
hi, this is laurent from belgium, sorry for my englich is no good lol
ok, i am search systeme simple for stop my print with because my fil pla is finish,
please hep mee,