MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
Yarn (I use up almost 12 meters)
A tape measure,
Verbatim TUFF 'N' TINY small flash drive (or something similar, you can purchase at http://www.kynix.com)
Cut the paper into 3.2 cm wide. The length of it is the same as your wrist circumference. Remember the length should leave more. After the outside is wrapped with yarn and fabric, the middle of the ring will be smaller.
Then folded the paper you cut down in half. And entangle it with tape. But leave the end openings. as shown in the first picture. The side cut open, and at the end of the tape, then tightening around outside. The head will become your U disk hat, so make sure it is enough to not let U disk slide out. Now you peel the flash drive shell off and use super glue to stick cardboard you fold a suitable thickness. At this time you should make the thickness of the flash drive fits the gap of the cardboard tube. Put the flash drive into your cardboard tube to another head and glue it down.
The color you want to use decides how long is each piece of yarn.
Fix the original yarn head with adhesive plaster. Then at the edge of the wristband paints super glue to prevent yarn slippage. Wind the yarn around wristband as tightly as you can. After a piece of yarn wrapped, as shown in the second picture you tie the string head at the end. You tie up another color of yarn. The new color of yarn bundles gently on the old color of yarn. Then all you can do is to make it tightly. All has been completed, you can use super glue to fix it under the end of the last one color yarn coat.
OK, quickly wear it on!
I so don't get what you are making.