Clicky

Loading

MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.

Download Now

Report as inappropriate

I've had my Anet A8 going with a BLtouch clone for a couple of years through marlin firmware.
Changed to klipper the other day and noticed that klipper didn't play well with the clone sensor, so i bought a genuine bltouch 3.1.
When i changed to the new sensor the printer won't boot properly.
If i disconnect the servo leads i can get the printer to boot, and once that is done i can connect the leads and get the sensor working as it should.

I have a couple of working theories right now:
Either i should set the output mode of the sensor to 5v, however i don't know if that's correct for the sensor pin on the motherboard.
Else the sensor draws too much current at boot so the board can't handle it.

As of right now i believe i have the sensor pin wired into the lcd same as the clone probe did.
I've seen some guys have disconnected the wire going to the lcd, but i can't find out why and if it has any drawbacks with this method.

Anyone else had this problem?