MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
On the Bltouch, I see the holder is printed in the traditional way, with the logo facing outwards (that's where the wires come out and go into the wire guide of the holder).
We would get better results if it was located with the logo facing inwards, as the internal circuit board would be further away from the magnets of the fan (when using dual fans) which would give more consistent bed levelling results. I had this issue with another makers fan duct I tried. As soon as I turned it around, the problems were fixed.
So could you make the Bltouch guide with the wire guide on the left, rather than the right, please.