MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
I joust had maiden last sunday. Four flight session of about 20 min each. Very very satisfied, slope condition were ok and plane likes to run quite fast. Authority of the stab is impressive and was forced to use 60% expo on stab and ailerons.
I put 15 gr ballast on the nose for safety but in the last fluight I removed 10 g and aerobatic goes better.
I never had AHI but I saw in flight. since there is a weight difference performances are different, but I fully enjoied.
Unfortunatly third flight session I found Rx battery completly drained at 50m above ground and I was lucky to find the crash site. Wings have survived but fuselage is broken in half. I changed battery and fly again after tape recovery, performances was not affected.
I liked very much the landing , during final approach pull stab gently and the plane lift the nose and land on the grass.
I was alone (except and old RC guy not able to record a video) so no video this time.