MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
Hi! I really like this design but I've found a few problems. I have a dual 5015 setup and I recently printed the dial mount for dual fans but unfortunately it sticks out to the side too much and therefore prevents the head from homing on the x axis as the mount hits the end switch housing on my cr10. I was going to use it with a prusa pinda probe as it fits that mount perfectly. The other problem I have is that the little tabs that join the base to the duct are very prone to breaking and don't hold the heavy dual 5015 setup very well. It wobbles up and down a bit and it it always sags down after adjusting the heigh. It would be great if you made these tabs much thicker and possible even switch those to m3 bolts? Also an additional mounting point somewhere towards the front would be great. As I've said earlier, two 5015 fans weight quite a bit and that weight always tilts the duct down. Especially after a few hundred hours of printing. But besides these two little problems I wouldn't change much. Best fan duct design out there ;)