MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
EDIT: 6:29 pm 04/28/19
This thing rocks! I had to reverse the bracket so the nut is captured in the bend which made it tricky to tighten. I also installed the cylinder. I found that with my side mount position the best position for this was slightly angled so at the Z axis goes up the bearings are always engaged. The spool is super slick and rotates like it's on ice!
EDIT 5:15 p, 04/28/19
I was able to file the holder threads with a "V" vile and with some lithium grease and a wrench able to slowly thread this on. 1/8 turn on, then back it off- repeat.
After getting it on, and running it up and down a few times I washed out the grease and it works fine with the .2 mm nut. I don't like the extra work but in this case it was WORTH IT. I'll see if I can upload my build to support your work.
The current file only has the .2 mm nut. Printed it and it does not fit. I may have damaged my near perfect Spool holders threads trying to install it. I can catch maybe 1- 2 threads then locks up. Forcing it further will just pop it off, damaging the threads on both
Did you also change the Spool Holder File as well?