MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
Customizer and this build don't play nice with each other. These are the settings I put into Customizer:
Using the following options:
LargeEndMeasured = inside
LargeEndDiameter = 67
LargeEndLength = 5
SmallEndMeasured = inside
SmallEndDiameter = 65
SmallEndLength = 40
TaperLength = 1
InsideStop = no
WallThickness = 4
If you add the two lengths and the taper, the part should be 5 + 40 + 1 = 46 mm. However, after Customizer finishes and I import the part into Cura, it shows a height of 87 mm !! I printed the part, and it prints at exactly that dimension.
I'll try again by using wrong numbers to see if I can get Customizer to spit out a part with the right length.
P.S. I did try it both with trailing zeros (67.0) and without (67). No difference.