Loading

MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.

Download Now

Report as inappropriate

Hello Bruno,

A short interim report from me:

I printed it all out and put it together. I had to polish the M3x30 screw round, because I didn't get any without a continuous thread. However, this thread always got caught in the spring.

  • Now I will connect GRND of the servo and of the light barrier with each other.
  • I do the same with 5V+ from the servo and from the sensor (right?).
  • Then I have an orange sensor cable from the light barrier and another cable (control) from the servo.

I would like to connect the 4 cables as follows:

  • I plug the cable from the light sensor into the endstop plug (1) and the cable from the servo into pin 27 (2). I connect GRND with the pin at (3) and 5V+ with the pin (4).

Do I connect the cables correctly?

Source for the pins: http://jonathanlundstrom.me/2017/10/23/cr-10-bltouch-firmware/