MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.
This is a really nice setup. I wish you had given an "exploded" view of how it goes together. A friend printed and suggested this to me. I was pretty stumped on how to affix it to the 713maker gantry. Remove rear screws, slide this over....ok, figured that out. Then had to back peddle a bit, remove lower two screws from back of pancake motor and replace with 2 M3x40. Those lower screws do a nice job "raising" the duct as needed. To make my install even more fun, I forgot to rotate the heater block! So, did that and decided to use the silicone sock. I printed the duct in polycarbonate, so between that and the sock, it should last a while!