Loading

MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.

Download Now

Report as inappropriate

I printed four of each for a total of eight pieces so no zip ties would be needed anywhere. This should be a drop in replacement for the zip tie method. I'm pretty sure the belts will work just fine and may even have a little bit extra. You can just print 4 copies of the belt_anchor_clip_set.stl file and be all set.

The parts with the slight cutout were suggested by a fellow MPCNC builder who had pipes that stuck out past the end of his towers and there was some interference with the lower belt mounts. If you have a similar setup, you can just print two of the normal set and then two of the belt_anchor_lower_clip_set.stl